Filter
Top Products
Preparations
3-2
2
Adjust the paper stopper in the rear portion of the
cassette by pressing in on the release buttons and
sliding the paper stopper to the fit the size of the paper
being loaded. The paper sizes are marked on the
bottom of the cassette.
The factory default setting is A4/Letter size paper. For
information on adjusting the paper stopper for Folio or
Oficio II size paper, see Adjusting the Paper Stopper
for Folio or Oficio II Size Page on page 3-3.
3
Adjust the paper width guides on both sides of the
cassette by pressing in on the release buttons and
sliding the guides to fit the width of the paper being
loaded in the cassette.
4
Set the paper in the cassette so that the leading edge
is aligned against the paper stopper, but making sure
that none of the paper gets caught on the overhanging
tabs.
Notes • Always adjust the paper stopper and paper width
guides before loading paper into the cassette.
Failure to do so may result in skewed paper feed
and/or a paper jam.
• Make sure that the paper is set securely against
the paper stopper and the paper width guides. If
there is any gap between the paper and the
stopper or guides, readjust the paper stopper
and/or the paper width guides, as appropriate.
• Make sure to face the side to be printed
downward.
• Be sure to load paper so that it is not folded or curled, etc.
• Do not load more paper than indicated by the lines located on the width guides.
5
Push the cassette securely all the way back into
the machine until it stops.