AGFA 1815 Copier All in One Printer User Manual


 
Optional Equipment
5-2
Acceptable Originals
Use sheet originals only
Paper weight: 50 to 120 g/m²
Paper sizes: 8
1/2 × 14"/Legal and Folio (Maximum), 5 1/2 × 8 1/2"/Statement and A5R (Minimum)
Maximum number which can be set at one time: 50 sheets (50 to 80 g/m²)
Originals to Avoid
Be sure not to use the following as originals in the document processor.
Originals with punched holes or perforations.
Transparencies.
Soft originals such as carbon or vinyl paper, or other originals that are curled, wrinkled or
creased.
Irregularly shaped originals, wet originals, or originals that have adhesive tape or glue on them.
Originals bound with clips or staples. (If you must use such originals, be sure to remove the
clips or staples, and straighten any curls, wrinkles or creases, before setting them in the
document processor. Failure to do so may result in the originals being jammed.)
Originals with cut-out sections or that have a slippery surface on either side.
Originals on which any correction fluid is still wet.
Originals with strong folds. (If you must use such originals, be sure to smooth out the folds
before setting them in the document processor. Failure to do so may result in the originals being
jammed.)
Names of Parts
1 Left Cover — Open this cover if an original jam
occurs.
2 Original Insert Guides — Align these guides to fit
the width of the originals to be copied.
3 Original Table — Set originals to be copied on
this table.
4 Original Eject Table — Originals that have been
copied are ejected and stored here.
5 Ejection Extension — Open this extension when
using larger sized originals such as
8
1/2 × 13"/Oficio II, 8 1/2 × 14"/Legal and Folio.
Setting Originals in the Document Processor
1
Adjust the original insert guides to fit the width of
original to be copied.
1
2 4 5
3