Filter
Top Products
Chapter 2 — Installing the scanner for the Macintosh computer 20
If your SnapScan will be connected to your computer together with
other SCSI devices
■ If you install the scanner at the end of your SCSI chain.
1. Remove the terminator from the last device in the SCSI chain.
2. Connect the 50-pin end of the SCSI cable to the connector that has become
available on this device.
3. Place the terminator on the free 50-pin connector of the scanner.
4. Connect the 25-pin end of the SCSI cable to the free connector of the
scanner.
5. Snap the diamond shaped wire clips into the clip brackets to secure the
connection.
❖ Note: In case of problems, refer to Appendix C, “Troubleshooting” .