Filter
Top Products
Chapter 3 — Installing the scanner for the PC 26
Installation of the hardware
This section shows you how to set up your SnapScan with your PC. You can find
information on the SCSI interface card, instructions for connecting the scanner to
your PC and instructions for testing the connection.
Installation with the Agfa supplied SCSI card
Installing the SCSI interface card
SnapScan requires a SCSI interface card to work with your PC, PC-AT
™
, 386,
486, or compatible computer.
We assume that you have no other SCSI devices installed and that you use the card and
cable that are supplied by Agfa.
1. Switch off your computer and disconnect the power cord.
2. Remove the cover of your computer.
3. Find a free 16-bit ISA expansion slot.
❖ Note: For more information, refer to your computer manual.
4. Remove the corresponding slot cover from the back of the computer chassis.
Keep the screw that held the cover in place.