Filter
Top Products
Chapter 3 — Installing the scanner for the PC 34
■ If you install the scanner between two other devices:
1. Disconnect your SCSI cable from one of these two devices.
2. Connect the free end of this SCSI cable to the scanner.
3. Connect the 50-pin end of the SCSI cable (the one supplied with your
scanner) to the other adjacent SCSI device.
4. Connect the 25-pin end of the SCSI cable (the one supplied with your
scanner) to the scanner.
5. Snap the diamond shaped wire clips into the clip brackets to secure the
connection.
6. Make sure that the last device in the chain is terminated.
Caution: Do not connect a terminator directly to the scanner in this configuration.
In case of problems, refer to Appendix C, “Troubleshooting” .