Filter
Top Products
INSert
Command MACHine{1|2}:SWAVeform:INSert <label_name>,
<bit_id>
The INSert command adds waveforms to the state waveform display.
Waveforms are added from top to bottom on the screen. When 96 waveforms
are present, additional waveforms replace the last waveform. Bit numbers are
zero-based, so a label with 8 bits is referenced as bits 0 through 7. Specifying
OVERlay causes a composite waveform display of all bits or channels for the
specified label. Specifying ALL inserts all of the bits individually.
<label_name> string of up to 6 alphanumeric characters
<bit_id> {OVERlay|<bit_num>| ALL}
<bit_num> integer representing a label bit from 0 to 31
Example OUTPUT XXX;":MACHINE1:SWAVEFORM:INSERT ’ABC’, OVERLAY"
OUTPUT XXX;":MACH1:SWAV:INSERT ’POD1’, #B1001"
MLENgth
Command :MACHine{1|2}:SWAVeform:MLENgth <memory_length>
The MLENgth command specifies the analyzer memory depth. Valid memory
depths range from 4096 states (or samples) through the maximum system
memory depth minus 8192. Memory depth is affected by acquisition mode.
If the <memory_depth> value sent is not a legal value, the closest legal
setting is used.
<memory_length> {4096 | 8192 | 16384 | 32768 | 65536 | 131072 | 262144
| 516096 | 1032192}
Example OUTPUT XXX;":MACHINE1:SWAVEFORM:MLENGTH 262144"
SWAVeform Subsystem
INSert
18–8