Introduction
The oscilloscope has four markers for making time and voltage
measurement. These measurements may be made automatically or
manually. Additional features include the run until time (RUNTil)
mode and the ability to center on trigger or markers in the display
area (CENTer) and . The RUNTil mode allows you to set a stop
condition based on the time interval between the X marker and the O
marker. When this condition is met, the oscilloscope will stop
acquiring data. Refer to Figure 32-1 for the Marker Subsystem Syntax
Diagram. The MARKer Subsystem commands are:
• AVOLt • TMAXimum
• ABVolt • TMINimum
• BVOLt • TMODe
• CENTer • VMODe
• MSTats • VOTime
• OAUTo • VXTime
• OTIMe • VRUNs
• RUNTil • XAUTo
• SHOW • XTIMe
• TAVerage • XOTime
This chapter only applies to the oscilloscope option.
32-2