Filter
Top Products
User’s ManualPage 2-14
humidity tolerances for the particular N-series printer in which it is installed.
Unpacking
After removing the X/TRA XLi from the shipping container, inspect the unit
for any damage in shipment. Immediately report any damage to the freight
carrier. Save the packing container. Do not remove the unit from its
antistatic enclosure until it is ready for installation.
Package Contents
Except when ordered otherwise, the X/TRA XLi includes the X/TRA XLi
internal protocol converter, this users manual, and an appropriate cable, as
ordered. Should any of these items be missing or damaged, contact an
AGILE sales representative.
N17 Installation
The following describes and illustrates how to install the X/TRA XLi in a
Xerox DocuPrint
®
N17 Network Laser Printer. For more information refer to
the users manual for your specific N-series printer model
Printer Preparation
▲ Turn the printer power off
▲ Disconnect the power cord and remove all cables
Opening the Printer
Use the following instructions to open the printer and refer to figure 2.1.
▲ Loosen the thumbscrews by turning them counter
clockwise.
Do not remove the thumbscrews.Do not remove the thumbscrews.
Do not remove the thumbscrews.Do not remove the thumbscrews.
Do not remove the thumbscrews.
CAUTION: Controller boards are sensitive to
static electricity. Before proceeding with the
removal of your printers controller board,
discharge any static electricity from your body
by touching something metal, such as the metal
plate on the back of the printer. Do this BEFORE
you handle the controller board.
▲ Remove the controller board by grasping both
thumbscrews and pulling toward you with firm and even
force.