User’s ManualPage 4-18
Tabs Horizontal
▲▲
▲▲
▲
COMMAND:COMMAND:
COMMAND:COMMAND:
COMMAND: s
t#t#
t#t#
t#
11
11
1
,#,#
,#,#
,#
22
22
2
,...#,...#
,...#,...#
,...#
6464
6464
64
d
▲▲
▲▲
▲
RANGE:RANGE:
RANGE:RANGE:
RANGE:
See See
See See
See
Margins Margins
Margins Margins
Margins
commandcommand
commandcommand
command
This command sets the horizontal tabs, where #
n
is the value of the tab
expressed in 1/60" or 1/300" units. As many as 64 horizontal tab values
may be entered.
For example, using a 1/60" unit of measure, to set tab stops at 0.75", 3.0"
and 4.5", enter:
st45,180,270d
The following list outlines the rules for setting horizontal tab stops:
▲ Default tab stops begin at 1.1" from the left side of
the page and are at every 0.44" thereafter.
▲ Tabs may be entered in any order.
▲ If more than 64 tab values are entered, the excess
tabs will be deleted, starting with the right most tab
value.
▲ The maximum tab position is 815 (13.58").
▲ Tabs are not effective beyond margins.
▲ If the page orientation is changed, the tab settings
must also be changed.
▲ Tab settings remain valid until the “Reset” or “Clear
Horizontal Tabs” commands are sent.
Tabs Clear Horizontal
▲
COMMAND:COMMAND:
COMMAND:COMMAND:
COMMAND: s
dd
dd
d
▲
RANGE:RANGE:
RANGE:RANGE:
RANGE:
N/AN/A
N/AN/A
N/A
This command clears all horizontal tab settings.
