Filter
Top Products
Page 4-9XES COMMANDS
occurs. The Configuration/Status Page is printed if the command is
followed immediately by a comma (,) or if an error is detected either
during the print job or during powerup.
The X/TRA XLi enables the user to determine the conditions in which a
Configuration/Status Page will be printed. Refer to Section 5
XTRAEDIT Configuration for information on specifying the conditions in
which a Configuration/Status Page will be printed.
The Configuration/Status Page includes the following information:
▲ The error number and error type, if any errors were
detected
▲ The names of any simulated, resident or downloaded
fonts
▲ The names of any downloaded forms
▲ An optional comment, if one was entered
▲ The current configuration
A sample Configuration/Status Page can be found in Section 6 Service
and Reference.
Optional Comment
An optional comment will be printed on the Configuration/Status Page if a
comment was entered directly after the comma in the XES command line
that triggered the Configuration/Status Page. The comma is a request for
printing a Configuration/Status Page. Whether or not this request is
honored can be determined by setting a parameter using XTRAEDIT. The
comment can be up to 132 characters in length.
The comment will always be printed by the XLi if a Configuration/Status
Page is printed.
Job Boundary Commands
A job boundary is a command function that tells the printer where the job
begins and ends, and it tells the printer what type of data the job contains.
The command to start printing a document is the Print Job command.
The command to end a document is the Reset command.