Filter
Top Products
Features in 291-08 12
Version 291-10
C613-10488-00 REV G
CR00012871
TTY 2 Unexpected characters could appear on the terminal emulator display
when the column size was set greater than 80 and the user edited a
command that spanned more than one line of the display.
This issue has been resolved.
YYYYYYYYYYY
CR00013597
DVMRP,
Frame Relay
2 If a frame relay interface was configured as a DVMRP interface, then the
DLC value was not correctly generated in output of the command show
config dynam or in the configuration script generated by the command
create config.
This issue has been resolved.
YYYYY- - - - - -
CR00013660
Core, SNMP 2 Previously, SNMP returned an incorrect product ID number for AR750S-DP
routers.
This issue has been resolved. The value of the sysObjectID object is now 80
for AR750S-DP routers.
--Y--------
CR00013735
LACP,
Switching
2 When moving ports from an LACP-controlled trunk to a manually-
configured trunk, ports were incorrectly set in an STP blocking state.
Therefore, traffic would not flow over the trunk.
This issue has been resolved.
Note: When you move ports from an LACP-controlled trunk to a manually-
configured trunk, you must delete the ports from LACP.
--------YY-
CR00013763
OSPF 2 If the obsolete command set ospf rip=both was entered, the router or
switch correctly automatically replaced it with the following two
commands in the dynamic configuration:
add ospf redistribute protcol=rip
set ospf rip=export
However, if the command create config was used to save the
configuration, after system start-up the configuration file did not contain
the command add ospf redistribute protocol=rip. This meant that OSPF
stopped redistributing RIP routes after a reboot.
This issue has been resolved.
YYYYYYYYYYY
CR Module Level Description
AR400
AR7x5
AR7x0S
Rapier i
Rapier w
AT-8800
AT-8600
AT-8700XL
x900-48
AT- 9900
AT-9800