Filter
Top Products
Features in 291-04 66
Version 291-10
C613-10488-00 REV G
CR00015936
Switch 2 It was not possible to set a tri-speed SFP to a fixed speed in the configuration
script that the AT-9924SP switch runs when it starts up.
This issue has been resolved, so the SFP can be set to a fixed speed from the
configuration script
Also, it was possible to use the command set swi port=number speed on an
empty SFP bay. The command reported that the operation had been successful,
but an inserted SFP was instead set to its previous or default setting.
This issue has been resolved. It is no longer possible to set the speed of an empty
SFP bay.
––––––––Y–
CR00015949
IPv6 2 Sometimes, when a router or switch received an IPv6 router advertisement
message, it incorrectly created a duplicate of an already-existing interface route.
If a user then deleted the IPv6 interface that these two routes belonged to, the
router or switch could reboot.
This issue has been resolved.
YYYYY––YYY
CR00015971
CR00015937
CR00015864
WAN Load
Balancing
2 The following issues occurred with WAN load balancing (WANLB):
■ when a WANLB resource port became unavailable, existing sessions on the
unavailable resource did not move to a backup resource
■ if packets were sent over a WANLB session, then that session timed out, and
then the same packets were sent again, a new session did not establish. This
stopped the packets from being sent the second time.
■ when WANLB was used with Firewall NAT, the orphan timeout setting of
WANLB sessions was not updated correctly. This could mean that WANLB
resources appeared to be available when they were not.
These issues have been resolved.
YYY–––––––
CR00016037
User 2 If the router or switch used RADIUS authentication and all the RADIUS servers
were unavailable, then the device correctly checked its user database for a
RADIUS backup user and authenticated that user. However, if that user then
logged out, they were unable to log in again until after the RADIUS server Dead
Time timer had expired.
This issue has been resolved.
YYYYYYYYYY
CR Module Level Description
AR400
AR7x5
AR7x0S
Rapier i
AT-8800
AT-8600
AT-8700XL
x900-48
AT- 9900
AT-9800