Filter
Top Products
Features in 291-08 22
Version 291-10
C613-10488-00 REV G
CR00004004
File 3 The show file command did not check whether the specified file system
was valid. If an invalid file system type was entered (such as show
file=abc:*.*), the router or switch reported that no files found instead of
reporting that the file system abc did not exist.
This issue has been resolved.
YYYYYYYYYYY
CR00005048
GUI 3 The following issues occurred with the GUI:
■ the menu item and related page title for configuring PPPoE and PPPoA
interfaces was incorrectly named “PPP”. This issue has been resolved by
changing the names to “PPPoE / PPPoA”.
■ the UPnP selection option on the firewall pages did not work. This issue
has been resolved.
Note that if you want to use the GUI to configure a PPP interface over ISDN,
use the Dial-up menu option to do so.
Y-Y--------
CR00005187
LACP 3 If a user attempted to enable LACP on AT-9800 series switches—which do
not support LACP—the switch incorrectly said that the module had been
enabled.
This issue has been resolved. The switch now displays an error message
instead.
----------Y
CR00005894
Classifier 3 Previously, a classifier with protocol=ip matched both IPv4 and IPv6
packets when used with software QoS, instead of only matching IPv4
packets.
This issue has been resolved.
YYYYY- - - - - -
CR00005940
BGP 3 There were several cases in BGP where an error was discovered in an
incoming packet, but the incorrect error subcode was reported in the
accompanying NOTIFICATION message. Also, NOTIFICATION messages did
not contain the aberrant data in their data fields, as required by the RFC.
These issues have been resolved.
YYYYYY- - YYY
CR Module Level Description
AR400
AR7x5
AR7x0S
Rapier i
Rapier w
AT-8800
AT-8600
AT-8700XL
x900-48
AT- 9900
AT-9800