Filter
Top Products
Features in 291-08 15
Version 291-10
C613-10488-00 REV G
CR00016587
IPv6 2 The timer that governs the interval between repeated neighbour
solicitation messages could only be configured by using the ndretrans
parameter of the set ipv6 nd command, and not through router
advertisements that the router or switch received from other routers.
This issue has been resolved. Instead of using the ndretrans parameter of
the command set ipv6 nd, use the retrans parameter to configure the
timer interval. Also,routers or switches acting as hosts will now correctly
update their timer values to the value specified in any router advertisements
that they receive.
YYYYYY- - YYY
CR00016592
DHCP6 2 Previously, it was possible to enter the incomplete commands delete
dhcp6 policy=name or set dhcp6 policy=name without specifying any
other parameters.
This issue has been resolved. If this is done, the router or switch now
displays the warning:
Warning (2117007): One or more parameters may be missing.
YYYYYY- - YYY
CR00016840
STP 2 Previously, when the switch was a Spanning Tree root bridge in a network
and a user raised the switch’s root bridge priority enough to stop the switch
from being the root bridge, unnecessary delays in convergence occurred.
This issue has been resolved.
- - - YYYYYYYY
CR00016956
IP Gateway 2 The set ip filter command would not accept the protocol parameter.
This issue has been resolved.
YYYYYYYYYYY
CR00016964
ISAKMP 2 When the router or switch negotiated an IPsec tunnel with RFC3947 NAT-
T, its NAT-OA payload had two bytes of reserved fields after the ID field
instead of the three bytes specified by RFC 3947. This could prevent the
tunnel from working properly when the tunnel was between an Allied
Telesis router or switch and some other vendor.
This issue has been resolved.
YYYYYY- - - - -
CR Module Level Description
AR400
AR7x5
AR7x0S
Rapier i
Rapier w
AT-8800
AT-8600
AT-8700XL
x900-48
AT- 9900
AT-9800