Filter
Top Products
Features in 291-05 42
Version 291-10
C613-10488-00 REV G
CR00016128
IPsec, IPv6 2 When the icmptype parameter was changed to none for an IPv6 IPsec policy, an
incorrect ICMP type value was displayed in output of the command show config
dyn and saved in the configuration file produced by the command create
config.
This issue has been resolved.
YYYYY- - - - -
CR00016180
GUI, Firewall 2 When configuring the firewall with the GUI, the Policy options tab did not
update its display when options were changed from the default settings. For
example, if the user cleared a checkbox and clicked the Apply button, the router
correctly turned off that option, but the GUI showed a check in the checkbox.
This issue has been resolved.
Y---------
CR00016200
Core 2 The router or switch’s handling of soft errors has been further improved. Soft
errors are spontaneous changes in the information stored in a digital circuit,
caused by physical effects.
YYYYYYYYYY
CR00016288
SYN 2 The polarity of the CD output of RS-232 DCE and V.35 DCE SYN cables was
reversed—it was ON when OFF was selected and vice-versa.
This issue affected AR750S, AR770S, and AR44xS series routers.
This issue has been resolved.
Y-Y-------
CR00016303
Load 2 The upload command did not always work if the server parameter was set with
the set load command instead of being specified in the upload command.
This issue has been resolved.
YYYYYYYYYY
CR00016327
IP Gateway 2 If a policy filter was configured, ping sometimes failed. This happened because
the router or switch assigned the ICMP echo replies to an IP flow without
checking that the interface for the echo replies matched the interface for the
flow. Therefore, the router or switch could use the wrong flow to forward the
replies.
This issue has been resolved.
YYYYYYYYYY
CR Module Level Description
AR400
AR7x5
AR7x0S
Rapier i
AT-8800
AT-8600
AT-8700XL
x900-48
AT- 9900
AT-9800