Filter
Top Products
Features in 291-08 27
Version 291-10
C613-10488-00 REV G
CR00011438
Ping 3 When the router or switch pinged a host whose hostname consisted only
of the digits 0-9 and the letters A-F, it treated the given hostname as a
hexadecimal IPX address even if the hostname was in the host list.
This issue has been resolved. Now, when the router or switch pings a host
using a hostname, it checks the hostname in the host list first. If it does not
find the host in the host list, then it treats the hostname as an IPX address.
YYYYYYYYYYY
CR00011824
Firewall 3 When a firewall UDP session starts up, the session timeout should be 5
minutes for the first 5 packets of the session, then change to the configured
UDP session timeout value. Previously, the timeout changed after the 6th
UDP packet belonging to that session, instead of after the 5th packet.
This issue has been resolved.
YYYYYY- - - - Y
CR00012066
IP Gateway 3 The command show ip cassi command is obsolete but was still available.
This issue has been resolved. The command has been removed from the
command line. To obtain the same information, use the command show
conf dyn=ip.
YYYYYYYYYYY
CR00012168
Classifier 3 Output of the show classifier command displayed only the hexadecimal
protocol value for IP SNAP, instead of also displaying the protocol name.
This issue has been resolved. The output now displays:
0000000800 (IP SNAP)
YYYYYYYYYYY
CR00012885
OSPF, GUI 3 If there were virtual OSPF interfaces, then the OSPF Interfaces GUI page
showed all interfaces as belonging to the backbone area (0.0.0.0).
This issue has been resolved.
YYYY- YYY- YY
CR00013352
STP 3 The help displayed by the command set stp port=all ? listed some
parameters twice.
This issue has been resolved.
- - - YYYYYYYY
CR Module Level Description
AR400
AR7x5
AR7x0S
Rapier i
Rapier w
AT-8800
AT-8600
AT-8700XL
x900-48
AT- 9900
AT-9800