Filter
Top Products
5Passing the external connector through the hole in the vertical plate, insert the card into
the communication slot. Press down on the card until the connector is solidly in place.
Don’t force the card. If you meet resistance, pull it out and try again.
If your card has a hook, make sure the hook engages the vertical plate.
6To see if the card is properly connected, lift it gently. If it resists and stays in place,
it’s connected.
Note: After you have finished these installation instructions and turned on
your computer, you may need to install software for your communication
card. If you installed an Ethernet card, you may also need to change the
network connection in the AppleTalk control panel. See the manual that
came with the card and “Connecting to an Ethernet Network” in the
section, “Connecting to a Network” in Chapter 3 for more information.
7If you have DIMMs or a High Performance Module to install, go to the next section in
this chapter. If you are finished installing items in your computer, proceed to “Closing
the Computer.”
144
Chapter 8