Filter
Top Products
74 Chapter 8 Working With File Services
Output
afp:command = "disconnectUsers"
afp:messageSent = "<message>"
afp:timeStamp = "<
time>"
afp:timerID = <disconnectID>
<user listing>
afp:status
= <status>
Canceling a User Disconnect
You can use the serveradmin cancelDisconnect command to cancel a
disconnectUsers command. Users receive an announcement that they’re no longer
scheduled to be disconnected.
To cancel a disconnect:
$ sudo serveradmin command
afp:command = cancelDisconnect
afp:timerID = timerID
Control-D
Output
afp:command = "cancelDisconnect"
afp:timeStamp = "<
time>"
afp:status
= <status>
Value Description
<message> The message sent to users in the disconnect announcement dialog.
<time> The time when the command was issued.
<disconnectID> An integer that identifies this particular disconnect. You can use
this ID with the cancelDisconnect command to cancel the
disconnect.
<user listing> A standard array of user settings for each user scheduled for
disconnect. For a description of these settings, see “Listing
Connected Users” on page 72.
<status> A command status code:
0 = command successful
Parameter Description
timerID
The integer value of the afp:timerID parameter output when
you issued the disconnectUsers command.
You can also find this number by listing any user scheduled to be
disconnected and looking at the value of the disconnectID
setting for the user.
Value Description
<time> The time at which the command was issued.
<status> A command status code:
0 = command successful
LL2354.book Page 74 Monday, October 20, 2003 9:47 AM