Filter
Top Products
Configure SNMP Parameters
Page 5-21
Adding a Trap Receiver Entry
Trap receivers are the management stations designated to
receive traps from the IntraSwitch 5308FL when they
occur.
∆ Note: The maximum number of trap receiv-
ers that can be added is four.
To add a trap receiver entry:
1
Open the SNMP Parameter Menu by typing n
in the Configuration Menu.
2
Type a to Add SNMP Trap Receiver Entry.
3
Type the IP address of the network manage-
ment station you want to receive traps.
▲ Important! Do not type an address of
0.0.0.0 or 255.255.255.255.
To cancel a selected option, press ctrl-c at
the command prompt.
4
Press return.
The trap receiver’s entry is added.
Deleting a Trap Receiver Entry
To delete a trap receiver entry:
1
Open the SNMP Parameter Menu by typing n
on the Configuration Menu.
2
Type d.
3
Type the IP address of the receiving network
station entry to be deleted.
4
Press return.
The trap receiver’s entry is deleted.