Configure Spanning Tree Parameters
Page 5-33
3
Select the port number you want to enable
or disable Spanning Tree on by typing l on
the Port Parameter Menu and entering the
port number at the prompt.
∆ Note: The 10/100TX port is port number 9,
the MII ports (MII I and MII 2) are port num-
bers 10 and 11, respectively.
4
Press return.
5
Type e to enable Spanning Tree on the port;
type d to disable Spanning Tree on the port.
6
Type q to exit this menu and return to the
Spanning Tree Parameter Menu.
7
Type a to apply the changes.
▲ Important! The change will not take
effect until Apply is selected from the Span-
ning Tree Parameter Menu.
