Filter
Top Products
2. Hardware Setup
9
Feature Cable Installation
The feature cable provides the ability to perform remote power on/off and reset
operations. The cable plugs into a header block located at the upper right of the
card. The block contains two rows of pins. The upper row comprises pins 1, 3,
5, and 7; the lower row comprises pins 2, 4, 6, and 8. To install the feature
cable, do the following:
1. Plug the feature cable’s large connector (the one containing all 4 wires)
into to the lower row of pins (pins 2–8) with the white wire at the top; the
orange wire at the bottom.
2. Unplug the leads from the computer mainboard’s Reset pin header. (These
are the ones coming from the computer case’s Reset switch).
3. Plug the feature cable connector containing the white and blue wires into
the mainboard’s Reset pin header.
4. Unplug the leads from the computer mainboard’s Power pin header.
(These are the ones coming from the computer case’s Power switch).
5. Plug the feature cable connector containing the white and orange wires
into the computer mainboard’s Power header.
(Continues on next page.)
White
Blue
White
Orange
W
B
W
O
To Mainboard
Reset Header
To Mainboard
Power Header
2
4
6
8
ip8000.book Page 9 Friday, May 9, 2008 10:39 AM