Filter
Top Products
IP8000 User Manual
22
Filtering
To enable IP and/or MAC filtering, Click to put a check mark in the IP Filter
Enable and/or MAC Filter Enable checkbox. There are a maximum of 100
filters allowed for each.
If the include button is checked, all the addresses within the filter range are
allowed access; all other addresses are denied access.
If the exclude button is checked, all the addresses within the filter range
are denied access; all other addresses are allowed access.
IP Filtering
To add an IP filter:
1. Click Add. A dialog box similar to the one below appears:
2. Specify the filter address in the dialog box, then Click OK.
A second dialog box, similar to the one below, appears:
3. To filter a single IP address, key in the same address as the start IP. To
filter a continuous range of addresses, key in the end number of the range.
4. After filling in the address, click OK.
5. Repeat these steps for any additional IP addresses you want to filter.
ip8000.book Page 22 Friday, May 9, 2008 10:39 AM