Filter
Top Products
Chapter 8. Device Management
141
The attribute setting details are the same as the ones that were discussed in
Chapter 6, Port Access. Refer back to Port Properties, page 86 for attribute
details.
Select any of the available options from the dropdown listbox for any port.
Note: With the GUI version, you can use [Shift] Click or [Ctrl] Click to
select several ports and set an attribute for all of them at the same time
After making your choices, click Save to save your settings and exit.
Reset on Exit
Place a check here to have the KVM Over the NET
TM
switch reset itself and
implement all the new settings when you log out. Following the reset, wait
approximately 30 to 60 seconds before logging back in.
For network IP address settings the Reset on exit check box is automatically
selected and the KVM switch will reset when you log out. Clearing the check
mark before logging out will cause the new IP settings to be ignored and the
original IP address settings will remain in effect.
Note: Even though the new IP information is ignored, it still remains in the
field. The next time you access this page Reset on Exit will be enabled.
The next time that the switch resets the IP settings that you thought you
discarded will be saved. To avoid this problem, you should be sure that
the IP settings that appear in the field are the ones you want to save.
kn2124v-4132.book Page 141 Tuesday, January 12, 2010 5:08 PM