Filter
Top Products
32 LongView® IP KVM Extenders Installer/User Guide
9. Press 6 to select the Network Speed option to toggle between Auto-Negotiate mode (option 1)
or 100Base TX full duplex mode (option 2).
Figure 3.12: Network Speed Menu
10. Type 0 (zero) and press Enter to exit and apply changes, or to return to the Network
Configuration Menu. If you made a mistake and do not wish to save the changes you made to
the network settings, type
C and press Enter.
NOTE: Changes to network configurations are applied only after you exit the Network Configuration Menu.
The LongView IP KVM user station will now automatically reset to apply the new network
configuration. During reset, the LongView IP KVM user station will drop its connection to the
transmitter. You will be returned to the Appliance Selection Menu screen. The connection will be
restored.
NOTE: The currently selected network speed, Auto-Negotiate, is marked with an asterisk.
Detecting a transmitter IP address
In the event that you forget the IP address of a transmitter, you can use the serial menu to detect the
IP address of a transmitter that is connected to the LongView IP KVM user station.
NOTE: This can only be done if the transmitter has been assigned a static IP address.
To detect the IP address of a connected transmitter:
1. Turn off the transmitter and directly connect it to the user station.
NOTE: If the transmitter receives its power from an external power supply, disconnect the transmitter from that
external power supply.
2. Press 1 to access the Receiver Main Menu and press Enter. If the password option is enabled,
you will be prompted for a password.