Filter
Top Products
46 LongView® IP KVM Extenders Installer/User Guide
Using the serial menu, you can disable the OSD time-out or change the time-out period to any
value between zero minutes and 10 hours. Setting the time-out period to zero means that the OSD
will not time out.
NOTE: You can dismiss the OSD at any time by pressing Esc.
To change the OSD time-out period:
1. From the serial menu, press 1 to access the Receiver Main Menu and press Enter. If the
password option is enabled, you will be prompted for a password.
2. Press 8 to access the Console Settings Menu and press Enter. The current OSD time-out
configuration is displayed beside menu item 2.
3. Press 2 to access the OSD Inactivity Timer Menu and press Enter.
Figure 3.27: OSD Inactivity Timer Menu
4. Press 2 to choose Inactivity Time and press Enter. You will be prompted to enter a time-out
period in the format hours:minutes (HH:MM). The maximum time-out period you can enter is
9 hours and 59 minutes (09:59).
5. Enter the time-out period and press Enter.
6. To confirm your selection and exit the screen, type 0 (zero) and press Enter.
NOTE: To disable the OSD time-out, press 1 to choose Disable in the OSD Inactivity Timer Menu.
Audio Performance Settings
You can use this option to modify the audio performance settings or to disable audio support. There
are three settings available: high, medium and off. The high setting provides the best audio
performance and should be used when high network bandwidth is available. The medium setting
should be used if network bandwidth is limited or if the network latency is high. If you choose off,
audio support will be disabled.