Filter
Top Products
Chapter 5: Advanced Operations 57
From the Transmitter Main Menu, press 7 and Enter to access the Console Settings Menu.
2. Press 7 and Enter to access the SAMI Menu for the user station.
-or-
Press 6 and Enter to access the SAMI Menu for the transmitter.
The Simple ASCII Management (SAMI) Menu will appear and show you the editable SAMI
settings, current port numbers and SAMI time-out settings.
New settings to the SAMI are not applied until after entering 0 to exit/apply changes. For proper
operation, once a command is sent, wait for a response before another command is sent. Each
command must be encapsulated in a single TCP/IP packet.
NOTE: The SAMI is disabled by default and uses password as the default password.
Figure 5.1: Simple ASCII Management Menu
To configure the following on the Simple ASCII Management Menu:
• To enable or disable the SAMI, press 1 to toggle back and forth. The screen will be refreshed
with the new setting.
• To change the default password, press 2 and enter your new password. You will be prompted to
re-enter your password. Press
Enter to complete this process.
• To change the port number (between 1024 and 65535), press 3.
• To enter the session time-out time (in minutes), press 4.
•Press 0 (zero) to exit and apply changes, or press c to cancel the changes, if any.
Example session
Send the use password password command terminated by a line feed (the response should be resp
connect).