Axis Communications Axis NPS 550 Printer User Manual


 
Section 8: Advanced Options
64 Axis NPS 550 User’s Manual
Action at Printer Busy
If the printer is busy when NPS 550 receives a new print job, you have
the choice between sending the print job to another logical printer, and
make the host wait until the printer is ready.
The default selection is ‘wait until printer is ready’. You may redirect
print jobs by specifying a secondary logical printer assigned to a different
printer port.
Example: The following entries in your config file will redirect PR1 print jobs to
PR3 when the printer assigned to PR1 is busy:
Note: Logical printer redirection cannot be nested. If the printer assigned to
PR3 in the example above is also busy, the print job will be held waiting
even if PR3 is further redirected.
Hex Dump Mode
When hex dump mode is activated, the print data will be printed as hexa-
decimal byte values rather than characters. Printer control commands are
also printed as hex values. This function is used for debugging purposes.
Example: The following entry in your config file will activate the hex dump mode
for PR3:
Note: The page length for hex dump printouts is determined by the Lines per
Page value of the PostScript Page Format parameter.
PR1_OUT. : LPT1
PR1_SCND. : PR3
PR1_WAIT. : NO
PR3_OUT. : LPT2
PR3_DUMP. : YES