Filter
Top Products
3-2
Location and Functions of Control
5976052 BARCOREALITY 9300 070999
COLOR
PHASE
SHARPN
TINT
BRIGHTN
STANDBY
ENTER
TEXT
EXIT
PAUSE
b. Remote control
This remote control includes a battery powered infrared (IR)
transmitter that allows the user to control the projector remotely.
This remote control is used for source selection, control,
adaptation and set up. It includes automatic storing of :
- picture controls (Brightness, Sharpness...)
- settings
Other functions of the remote control are :
- switching between standby and operational mode.
- switching to "pause" (blanked picture, full power for
immediate restarting)
- direct access to all connected sources.
Remote Control (RCU)
Local keypad
Terminology
1 Function keys : have no function for this projector
2 ADJ. : ADJUST key, to enter or exit the adjustment mode.
3Address key (recessed key), to enter the address of the projector (between 0 and 9). Press the recessed address key with
a pencil, followed by pressing one digit button between 0 and 9.
4 Selection key : no function.
5 PAUSE : to stop projection for a short time, press 'PAUSE'. The image disappears but full power is retained for immediate restarting.
6 STBY : stand-by button, to start projector when the power switch is switched on and to switch off the projector without switching
off the power switch.
Attention : Switching to Stand-by.
When the projector is running and you want to go to stand-by, press the stand-by key for 2 seconds until the message 'Saving
data, please wait' is displayed. Do not press any longer on the stand-by key otherwise the projector will restart.
7 Mute : to interrupt the sound reproduction.
8 Help : on line help information (not yet available)
9 Digit buttons : direct input selection.
10 Audio controls : use these buttons to obtain the desired sound level (see also 'Controlling').
11 Picture controls : use these buttons to obtain the desired picture analog level (see also 'Controlling').
12 PHASE : used to remove the instability of the image.