Filter
Top Products
Service Mode
10-4 5976052 BARCOREALITY 9300 070999
Select with or
then <ENTER>
<EXIT> to return.
Select with or
then <ENTER>
<EXIT> to return.
Select with or
then <ENTER>
<EXIT> to return.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTINE HISTORY
Select with or
then <ENTER>
<EXIT> to return.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTINE HISTORY
LAMP DRIVE MODE
MORE ...
CHANGE PROJ. ADDRESS
Enter new address
001
Select with or
Reprogram with or
or numeric keys
<ENTER> to confirm
<EXIT> to return
Change Projector Address
Every projector requires an individual address between 0 and 255.
This address can be software installed.
To change that address :
1 Push the cursor key é or ê to highlight 'Change Proj.
Address'.
2 Press ENTER.
The Change Projector Address menu will be displayed and
the actual address will be filled in.
The first digit is highlighted. Enter the new projector address
with :
1 the digit keys on the RCU or the local keypad or
2 use the control disc to the right or to the left to select a digit
and change the value by pushing the control disc up or down
until the new value is reached. Continue with the other digits
on the same way.
Change Baudrate PC
The communication speed between projector and computer, e.g. PC
or MAC, has 8 possible speeds. The baud rate speed can be
software set.
1 Push the cursor key é or ê to highlight 'Change Bau rate PC'.
2 Press ENTER to display the Change Baudrate PC menu.
The following baud rates are available :
230400/115200/57600/38400/19200/9600/4800/1200
The actual baud rate will be highlighted.
To change the baud rate :
1 Push the cursor key é or ê to highlight the new baudrate
setting.
2 Press ENTER to accept.
Reset Lamp Runtime
Reset lamp run time is only allowed when a new lamp is installed.
1 Push the cursor key é or ê to highlight 'Reset Lamp Runtime'.
2 Press ENTER to select.
When Reset Lamp Run Time is selected in the Service Mode selection
menu, the following warning will be displayed :
Risk of electrical shock. Reset lamp run time is reserved to qualified
service personnel.
If you are not qualified, press EXIT to cancel the reset operation.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTINE HISTORY
LAMP DRIVE MODE : NORMAL
MORE...
Select with or
then <ENTER>
<EXIT> to return.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTINE HISTORY
LAMP DRIVE MODE
MORE
WARNING
-----------------------------------------------------
RISK OF
ELECTRICAL SHOCK
______________________________________________________________
RESET LAMP RUN TIME
is reserved to
qualified
service personnel
<ENTER> to accept
<EXIT> to return.
Change Language
1 Push the cursor key é or ê to highlight 'Change Language'.
2 Press ENTER to display the language selection menu.
Available languages : English
CHANGE LANGUAGE
English