Filter
Top Products
Service Mode
10-3
5976052 BARCOREALITY 9300 070999
RGB V
RGB
H / C
V
On
98 27910
RGB
H / C
V
H
RS 232 IN
REMOTE
PROJECTOR MODE :
GREEN - OPERATION
RED - STANDBY
COMMUNICATION PORT
(800-PERIPHERALS)
RS232 OUT
IR-ACKNOWLEDGED
IR-REC EIVE D
DIAGNOSTICS
COD E IR-RECEI VER
0
I
This device complies with Part 15 of the FCC rules. Operation
is subject to following two conditions :
(1) This device m ay n ot cause harm ful interference
(2) This device must accept any interference received
including interference that may cause undesired operation
RGB V
RGB
H / C
V
On
98 279 10
RGB
H / C
V
H
RS 232 IN
REMOTE
PROJECTOR MODE :
GREEN - OPERATION
RED - ST ANDBY
COMMUNICATION PORT
(800-PERIPHERALS)
RS232 OUT
IR-ACKNOWLEDGED
IR -REC EI VED
DIAGNOS TICS
CODE
IR -REC EI VER
0
I
This device complies with Part 15 of the FCC rules. Operation
is subject to following two conditions :
(1) This device may not cause harmful interference
(2) This device mus t accept any interference received
including interference that may ca use unde sired operation
Select with or
then <ENTER>
<EXIT> to return.
Password switch
Change Password
This item is password protected when the password switch is in the
ON position.
How to enable or disable the password function ?
The password function is enabled when the password switch,
second switch of S2, on the controller module is in the ON position.
To get access to the controller module, proceed as follows :
1 Power down the projector and disconnect the power cord
from the wall outlet.
2 Turn both lock screws on the side of the front top cover with
a screwdriver or coin counter clockwise.
3 Lift up and pivot the top cover.
Attention : the cover is not secured with an incorporated
support. When opening, turn it over slowly and lay it down
on the second part of the top cover.
Loosen the locking
screws.
Open the top cover
How to change the password ?
1 Push the cursor key é or ê to highlight 'Change password'.
2 Press ENTER to display the Change password menu.
The old password is displayed and can be changed by entering the
digit with the numeric keys of the RCU or local keypad.
Press ENTER to save the password.
Press EXIT to return without saving the new password.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTINE HISTORY
LAMP DRIVE MODE
MORE...
CHANGE PASSWORD
Enter new password
0000
Select with or
then <ENTER>
<EXIT> to return.