Specifications
ETEP Installation Guide 21
Specifications
This section lists the mechanical and environmental specifications for the following ETEP models:
• ET0010A specifications are listed in Table 7
• ET0100A specifications are listed in Table 8
• ET1000A specifications are listed in Table 9
• ET10000A specifications are listed in Table 10
Device Management • EncrypTight Manager software for device and policy
management
• Out-of-band management
• Alarm condition detection and reporting
• Syslog support
• SNMPv2c and SNMPv3 managed object support
• Audit logging
• Management access using X.509 v3 digital certificates
• Security options include TLS, SSH, IKE/IPsec
Network Support • Ethernet
• VLAN tag preservation
• MPLS tag preservation
• Jumbo frame support
• Link state pass-through
• IPv4
• IPv6 (Layer 2 Ethernet encryption mode)
• NTP
• Host or gateway packet reassembly option
Policy Selector Options • Source or destination IP address
• Source or destination port number
• Protocol ID (Layer 3 IP packet and Layer 4 payload options)
• VLAN ID (Layer 2 encryption option)
• Multicast address
Table 7 ET0010A Mechanical and Environmental Specifications
Category Specification
Interfaces (2) 10/100 Mbps Ethernet ports for encrypting and decrypting
traffic
(1) 10/100 Mbps Ethernet auxiliary port
10/100/1000 Mbps auto-sensing Ethernet LAN port for
management
RS-232 port for management
Table 6 ETEP Feature Summary
Category Feature