Filter
Top Products
Diagnostic Code Display
ETEP Installation Guide 75
Diagnostic Code Display
ETEPs display self-test codes during boot up, in addition to operational status and error conditions. See
the following sections for information about your appliance model.
Status Codes: ET0010A
The ET0010A status LEDs display self-test codes during boot up. After the ET0010A boots, the status
LEDs reflect the operational state of the appliance.
When the appliance powers up, the Alarm LED illuminates briefly and the four status LEDs illuminate to
verify that they are functioning. As the ET0010A cycles through its self-tests the status LEDs indicate the
self-test that is in progress (see Table 28). After the tests execute successfully, the status LEDs turn off.
If the ET0010A fails to boot properly the illuminated status LEDs indicate the number of the last test that
completed successfully, and a message describing the failure is displayed on the terminal. In addition, the
Alarm light illuminates if any of the first four self-tests fail (status LEDs 1, 2, 1&2, or 3). In the event of
a failure, make a note of the status code and of the error message on the console, and then contact Black
Box customer support.
After the ET0010A boots up
, the status LEDs reflect the operational state of the appliance.
Table 28 ET0010A Self-Tests
Status LEDs Illuminated Description
1, 2, 3, 4 LED display test.
1 Bootflash CRC test.
2 DRAM test #1.
1, 2 Initialize IO devices. DRAM test #2.
3 Initialize compact flash.
1,3 Complete bootloader initialization.
2,3 Download operating system.
1, 2, 3 Start operating system, IPSec dataplane code, and management
and control software.
1, 3, & 4 Restart/reboot command issued.
All status LEDs off Up and operational.