Filter
Top Products
ETEP Installation Guide 35
Figure 22 ET0010A Cabling
NOTE
The Aux1 port on the ET0010A is not enabled in this release.
Powering On the ET0010A
Use the following procedure to power up the ETEP.
Figure 23 Attaching the power cables on the ET0010A-402
To power on the ETEP:
1 Check that the power supply cable is properly inserted in the power connector on the ETEP rear
panel. The ET0010A-402 is shown in Figure 23. On the ET0010A, the power connector is on the
right side of the rear panel.
2 Plug the power cord into the ETEP power supply. Attach the opposite end to a power source to apply
power to the appliance.