Filter
Top Products
ETEP Installation Guide 33
Figure 19 Screw holes for rubber feet installation on bottom of unit
3 Place one of the rubber feet over the hole and insert a screw into the opening (Figure 20). Tighten the
screw.
Figure 20 Rubber feet installed
4 Repeat step 3 for the remaining feet.
5 Turn the unit over so that it is resting on the rubber feet.
6 Attach the external power supply to the power connector on the rear panel.
Figure 21 shows the ET0010A-402 rear panel and power supply. On the ET0010A, the power
connector is located on the right side of the rear panel.