Filter
Top Products
Installation
48 ETEP Installation Guide
Cabling Requirements: ET10000A
Table 19 outlines the standard cables used with each port on the ET10000A. The connector type listed
indicates only what is required to connect to the ET10000A port, and may or may not be the same
connector type required for the other end of the cable. Some cables are supplied by Black Box and others
are user-supplied.
NOTE
To meet the requirements of FCC Part 15 and the EU EMC Directive 2004/108/EC, use only shielded
Category 5 cables with the ET10000A Ethernet management port
.
Table 19 ET10000A Standard Cables
ET1000A Port Cabling Supplied by...
Power receptacles Power supply cables certified
and approved for use in the
country of interest
Black Box
RS-232 Port 1.8 meter shielded null modem
able with an RJ45 connector at
one end and a DB9 female
connector at the opposite end.
Black Box
10/100 Ethernet Management
Port (RJ-45)
Unshielded Category 5 straight
through cable (STP), RJ-45
connector
a
a. The 10/100 Ethernet management port is auto-sensing for polarity. You can use a unshielded Category 5 straight
through cable or a
unshielded crossover cable when connecting to this port.
Black Box
Gigabit Ethernet Management
port (SFP)
Not applicable. Port is not
enabled in this release.
Not applicable
USB Management port Not applicable. Port is not
enabled in this release
Not applicable
Local and Remote Gigabit
Ethernet ports
• Optical SFP transceivers
• 1000Base-LX SFPs
9/125m single-mode duplex
fiber or simplex fiber pair (1
transmit, 1 receive), 1310 nm
nominal wavelength, LC
connector
OR
• 1000Base-SX SFPs
62.5/125m multi-mode
duplex fiber or simplex fiber
pair (1 transmit, 1 receive),
850nm nominal wavelength,
LC connector
Available as accessory options
Local and Remote Gigabit
Ethernet ports
• Copper SFP transceivers
Unshielded Category 5 straight
through cable (STP), RJ-45
connector
Available as accessory options
Aux1 ports (SFP and RJ-45) Not applicable. Ports are not
enabled in this release.
Not applicable