Filter
Top Products
56
CHAPTER SIX
Dual Access
You can scan up to 50 documents into the fax memory, even while the MFC
is receiving or sending another fax (from memory). You can set temporary
settings for each fax you're scanning, except Timer and Polling.
If you try to scan in and store a 51st fax, the MFC will send it immediately,
without storing it in memory.
If you get a MEMORY FULL message while scanning the first page of a
fax, press
Stop
to cancel scanning. If you get a MEMORY FULL message
while scanning in a subsequent page, you'll have the option to press
Start
to
transmit the pages scanned so far, or to press
Stop
to cancel the operation.
1
Make sure the document feeder is empty.
2
Place the document in the feeder.
3
Enter the fax number.
4
Press
Start
. The MFC starts scanning the document and the screen
displays the job number (#XX) of the fax and how much memory is
available. Then the MFC starts dialing. You can immediately repeat
steps 1 through 4 for the next fax.
Your MFC normally operates in Dual Access mode. However, you can
override Dual Access by using Real Time Transmission.
Real Time Transmission
When Memory is full, the MFC cannot continue to scan documents into
memory before sending. However, you can turn on REAL TIME TX; place
the documents in the feeder and enter the fax number. As soon as the phone
line is free, the MFC starts dialing and sending the fax.
1
Place the document in the feeder.
2
Press
Function
,
1
,
3
,
9
.
The screen displays
9.REAL TIME TX
3
Press
Set
.