Filter
Top Products
13
STEP
1
STEP
2
STEP
3
For WindowsFor Macintosh
STEP
4
Introduction
Before using the
printer
Maintenance and
Troubleshooting
Using only this printer
(No PC)
Connecting to your PC
CD/DVD Film Labels
• In prior to use, be sure to follow the instructions in your CD/DVD player's instruction
manual regarding applying CD/DVD labels.
• Do not use CD/DVD labels in a slot loading CD/DVD player, for example a CD player in
a car where the CD is slid into a slot in the CD player.
• Do not peel off the CD/DVD label once it is applied to the CD/DVD.
• A thin surface layer may come off, resulting in damage to the disk.
• Do not apply CD/DVD labels to CD/DVD disks designed for use with ink jet printers.
Labels peel off of these disks easily, and using disks with peeled labels can result in loss
or damage of data.
• When applying CD/DVD labels, use the applicator included with the CD/DVD label rolls.
Doing so could cause damage to the CD/DVD player.
• User's shall take full responsibility for applying CD/DVD labels. Brother accepts no
responsibility for any loss or damage of data caused by the inappropriate use of CD/DVD
labels.
CD-ROM and Software
• Do not scratch the CD-ROM and place the CD-ROM onto the place with extremely high
or extremely low temperatures.
Also, do not put heavy objects on the CD-ROM or apply force to the CD-ROM.
• The software contained on the CD-ROM is meant for use with the printer only. See
License on CD for further details. This software may be installed on multiple personal
computers for use at an office, etc.
Battery
• Do not use included battery to other products.
• Dispose in accordance with all applicable federal, state,
and local regulations.
• When storing or discarding the battery, wrap it with
adhesive cellophane tape etc. to prevent the short circuit of
battery.
• It is recommended to replace the battery every two years.
Cutter
• The average number of cuts is 5,000 or more depending on the operating environment.
Dull cut, the inability to cut straight, or frequent paper jams may indicate that the cutter
life is near the end. Replace the cutter if these conditions occur.
Note that Brother does not assume responsibility for any damage, etc. arising from failure
to follow the precautions listed.
Adhesive cellophane tape etc.
Battery
Example of grounding of battery