Filter
Top Products
Port Filtering Configuration Screen
802.1Q VLAN User’s Guide 3-17
3. When the desired VLAN ID is displayed, use the arrow keys to
highlight the SAVE command at the bottom of the screen.
4. Press ENTER. The message “SAVED OK” displays.
3.5.3 Paging Through the Port List
To display additional ports that do not display in the current screen, use
the NEXT or PREVIOUS commands at the bottom of the screen, as
follows:
1. To display the next screen, use the arrow keys to highlight NEXT.
Press ENTER to view the entries on the next screen.
2. To display the previous screen, use the arrow keys to highlight
PREVIOUS. Press ENTER to view the entries on the previous screen.
3.6 PORT FILTERING CONFIGURATION SCREEN
When to Use
To perform the following functions:
• Select a port and view a list of VLANs that are configured to have their
frames transmitted out that port.
• Filter out certain incoming frames according to the VLAN List and
prevent them from being switched and transmitted out another port.
• Filter out of all incoming untagged frames so they will not be
transmitted out another port.
NOTE
New VLAN IDs must be created with the functions available on
the Device VLAN Configuration screen, discussed in
Section 3.4.
NOTE
The NEXT and PREVIOUS fields will only display if there are
further Port List entries to page through.