Filter
Top Products
Protocol VLAN Configuration Screen
802.1Q VLAN User’s Guide 3-29
1. Use the arrow keys to highlight the VLAN ID field at the bottom of
the screen.
2. Enter the VLAN ID. If a new VLAN ID is entered that has not been
created on the switch, use a unique number between 2 and 4094. The
VLAN IDs of 0, 1, and 4095 may not be used for user-defined VLANs.
A FID will automatically be assigned to the new VLAN ID. The FID
assigned will have the same value.
If an illegal number is entered, the Event Message Line will display:
”PERMISSIBLE RANGE FOR VLAN IDS: 2 to 4094” and the field
will refresh with the previous value.
3. Use the arrow keys to highlight the Protocol field at the bottom of the
screen.
4. Use the SPACE bar to step to the appropriate protocol type; IP, IPX,
Appletalk, Netbios, Banyan Vines, DECNET, or CUSTOM. If
CUSTOM is selected, Ether Type 0x0 displays. The user’s own Ether
Type can then be entered if necessary.
5. Use the arrow keys to highlight the Configure Ports field near the
bottom of the screen.
6. Press the SPACE bar to toggle the field to apply the VLAN ID and
Protocol Type entries to either ALL PORTS or NO PORTS.
NOTE
Each VLAN ID must be unique. If a duplicate VLAN ID is
entered, the switch assumes that the Administrator intends to
modify the existing VLAN.
NOTE
Any Ether Type entered in the Ether Type field and saved will
become part of the selection in the Protocol field.
TIP
To see if there are VLANs currently assigned to the Protocol
displayed in the Protocol field, press ENTER.