Filter
Top Products
2-10
Unpacking and Installing Your ELS100-16TX
2.6.1 Connecting UTP Cables
Before connecting a segment to the ELS100-16TX, check each end
of the segment to verify wire crossover.
Connect a twisted pair segment to the ELS100-16TX as follows:
1. Ensure that the device at the other end of the segment is
connected to the segment and is powered ON.
2. Refer to Figure 2-5. Connect the twisted pair segment to the
ELS100-16TX by inserting the RJ45 connector on the twisted
pair segment into the desired RJ45 port.
.
Figure 2-5. ELS100-16TX Twisted Pair Connection
3. Verify that a Link exists by checking that the port LINK LED is
on (solid green). If the LINK LED is off, perform the following
steps until it is on:
a. Check that the 10/100 BASE-T device at the other end of
the twisted pair segment is ON and connected to the
segment.
Caution: To establish a link, you must have an odd number of crossovers
(preferably one) between 10/100 BASE-T devices of the same
type (i.e., from repeater to repeater or transceiver to
transceiver).
PWR
CPU
RESET
COM
PORT STATUS MODE
TXACTFDXMON
RXCOL100USR
STATUS
EPIM100
EPIM100
10X 12X 14X 16X
9X 11X 13X 15X
2X 4X 6X 8x
1X 3X 5X 7X
LINK
STATUS
LINK
STATUS
2 4 6 810121416
135
7
9111315
ELS100-16TX