Filter
Top Products
Users in the U.S.A.
xxi
Users in the U.S.A.
Users in Canada
Pre-Installation Requirements for Canon Facsimile Equipment
A. Location
Supply a suitable table, cabinet, or desk. See p.
14-2 for the machine’s weight and dimensions.
B. Order Information
1. Provide only a single-line to touch-tone or rotary telephone set terminated with a standard 4-pin
modular phone plug. (Touch-tone is recommended if available in your area.)
2.
Order an CA11A modular jack (USOC code), which should be installed by the telephone company. If
the CA11A jack is not present, installation cannot occur.
3.
Order a normal business line from your telephone company’s business representative. The line
should be a regular voice grade line or equivalent. Use one line per machine.
DDD (DIRECT DISTANCE DIAL) LINE
-or-
IDDD (INTERNATIONAL DIRECT DISTANCE DIAL) LINE IF YOU COMMUNICATE OVERSEAS
Canon recommends an individual line following industry standards, e.g., the 2500 (touch tone) or 500
(rotary/pulse dial) telephones. A dedicated extension off a PBX machine without “Camp On” signals is also
permissible with the machine. Key telephone systems are not recommended because they send non-standard
signals to individual telephones for ringing and special codes, which may cause a fax error.
C. Power Requirements
The power outlet should be a three-prong grounded receptacle (Single or Duplex). It should be
independent from copiers, heaters, air conditioners or any electric equipment that is thermostatically
controlled. The rated value is 120 volts and 15 amperes. The CA11A modular jack should be relatively
close to the power outlet to facilitate installation.