Filter
Top Products
Overview of the imageRUNNER 5075/5065/5055/5050
2-12
2
Basic Operations
■ Auto Sleep Mode
You can set the machine to enter the Sleep mode whenever you desire, by pressing the
control panel power switch. To reactivate the machine, press the control panel power
switch again.
NOTE
•
The machine may not enter the Sleep mode completely depending on certain conditions.
(For more information, see "Energy Consumption in the Sleep Mode," on p. 4-37.)
•
Turn the control panel power switch OFF when not using the machine for a prolonged
period of time, for example, at night.
•
If a Macintosh, which has been shut down, is connected to the machine via a USB cable,
when the machine returns from the Sleep mode, the Macintosh may turn ON. In this
case, disconnect the Macintosh from the machine. (You may also be able to solve this
problem by using a USB hub between the machine and the Macintosh).
•
The time it takes for the machine to automatically enter the Sleep mode can be set from
10 seconds to 4 hours. The default setting is '15' minutes. (See "Auto Sleep Time," on p.
4-56.)
•
If Energy Consumption in Sleep Mode is set to 'Low', it may takes more than 10 seconds
for the touch panel to be displayed after pressing the control panel power switch.
■ Quiet Mode
If the machine is not used (no keys are pressed) for a certain period of time (after the last
print job or key operation is performed), the device sounds from the machine stop, and the
machine enters the Quiet mode.
NOTE
The time for the machine to enter the Quiet Mode can be set from 0 to 9 minutes in one
minute increments. (See "Time Until the Unit Quiets Down," on p. 4-57.)
■ Daily Timer
The machine automatically enters the Sleep mode at the specified time and day of the
week set with the daily timer. To reactivate the machine, press the control panel power
switch.
NOTE
The Daily Timer settings can be set from Sunday to Saturday and 00:00 to 23:59. (See
"Daily Timer Settings," on p. 4-58.)