Canon B150 Fax Machine User Manual


 
Cannot receive using Error Correction Mode (ECM)?
Does the other party’s fax support ECM?
Some fax units do not support ECM transmission. If the other party’s fax
does not support ECM, the document is sent in the normal mode without
error checking.
Is your fax set for ECM receiving?
ECM receiving can be turned off and on. Check the current setting. See
p. 85.
Nothing prints?
Did you remove the orange tape from the BJ cartridge before you installed it
in the fax?
Be sure to remove the orange tape from the BJ cartridge before you install
it in the fax. See p. 11.
Make sure the BJ cartridge is installed correctly. See pp. 11 13.
Clean the print head several times. See p. 102.
Try another BJ cartridge.
Are the images you print blotched or uneven?
Are you using ECM sending/receiving?
ECM sending/receiving should eliminate such problems. However, if the
telephone lines are in poor condition, you may have to try again.
How is the quality of the other party’s fax?
Remember, the sending fax usually determines document quality. Be sure
the other party’s back of top cover and scanning glass are clean.
TELEPHONE
Cannot dial?
Is the telephone line connected to the fax?
Be sure the telephone line is correctly connected to the fax. See p. 14.
Is the fax set for the type of telephone line in use (pulse/tone)?
If you have a tone line, be sure the fax is set for tone dialling. If you are
not sure what type of line you have, contact your local telephone company.
See p. 16.
Does the phone disconnect while you are talking on the line?
Is AnsMode displayed on the LCD?
If AnsMode is displayed on the LCD, press [RECEIVE MODE] to select
a different mode. The Ans. Machine Mode should only be on when an
answering machine is connected, turned on, and ready to take messages
from telephone callers.
SOLUTIONS TO COMMON PROBLEMS
106