Filter
Top Products
TX SETTINGS
Factory settings are in bold. For instructions on how to change a setting, refer to How to change a
setting, pp. 81, 82.
Name Description Settings
ECM TX Enable/disable error correction during transmission.
ON/OFF
MID PAUSE SET Set the length of the pause you insert into a dialling
sequence.
2 seconds (1 to 15)*
AUTO REDIAL Detemine whether the fax will redial a number if it fails to
get a response on the first attempt.
ON/OFF
REDIAL TIMES Set the number of retries.
2 times (1 to 10)**
REDIAL INTERVAL Set the period of time between rediallings.
2 minutes (2 to 60)
*4 seconds (4-11) in the UK and Hong Kong.
**Up to 4 times in the UK and Ireland, and 5 times in New Zealand.
RX SETTINGS
Factory settings are in bold. For instructions on how to change a setting, refer to How to change a
setting, pp. 81, 82.
Name Description Settings
ECM RX Enable/disable error correction during reception.
ON/OFF
FAX/TEL SWITCH Enable/disable FAX/TEL switchover. When ON, this feature
answers calls, and if no fax tone is detected, the fax rings
to alert you of an incoming call.
RING START TIME Set the duration that the fax listens for a fax tone before
starting to ring.
8 seconds (0 to 30)
F/T RING TIME Set the length of time the fax will ring to alert you of an
incoming call.
22 seconds (10 to 300)
F/T SW ACTION Selectthe action taken after the F/T RING TIME expires.
DISCONNECT/RECEIVE
INCOMING RING Whenthe fax is set to Fax Only Mode or Fax/Tel Mode and
an extension phone is connected, set the fax to ring when
it receives a call.
ON/OFF
RING COUNT Set the number of incoming rings before the fax answers.
2 times (1 to 99)
MAN/AUTO SWITCH Determine if the fax switches to document receive mode
after the fax rings for a specified time when the fax is in the
manual receive mode.
ON/OFF
RING TIME Set the amount of time the fax will ring before switching to
document receive mode.
10 seconds (1 to 99)
REMOTE RX Allows you to dial the REMOTE RX ID on an extension
phone to start receiving a document.
ON/OFF
REMOTE RX ID If you set REMOTE RX ON, you can change the remote
receiving ID.
25 (00 to 99, including and #)
MEMORY RX Turn on/off memory receiving of a document.
ON/OFF
SETTINGS
7777777777777777777777777777777777777777777777777777777777777777777777777777777777777
85