Filter
Top Products
75
2
Perform the procedure under “To switch the YP-100 connection profile” (page 68)
to switch the YP-100 connection profile to “Manual Connection 3”.
z This will cause the “Standing by for connection...” screen to appear in the projection
area. Confirm that the screen shows “Manual Connection 3” for the connection profile.
3
On the Wireless Connection window, select “Switch Connection Profile” on the
“Connection” menu.
z This will display a dialog box for switching the connection profile.
4
Click the [New] button.
z This will display a dialog box for configuring a new manual connection profile.
5
On the dialog box for configuring the manual connection setup, configure the
settings so they are the same as those that you configured for Manual
Connection 3 in step 1 of this procedure.
z Make sure that the IP address is different from the IP address you set in step 1, the IP
address of the access point, and any other IP address within the same network.
z For details about each of the settings on the dialog box, see “Manual Connection Setting
Reference” (page 79).