Filter
Top Products
88
The wireless LAN connection between the YP-100 and computer keeps
dropping.
This can be caused by the following.
• Data communication can slow down and the connection may tend to drop when the YP-
100 and computer are far from each other (in different rooms, on different floors, etc.)
Move the YP-100 and computer as close together as possible.
• Operation of a device that uses the 2.4 GHz frequency band (which is the same
frequency band as the IEEE802.11b wireless standard used by the YP-100) in the
vicinity of the YP-100 can cause radio interference that results in a wireless
communication error. Avoid using the nearby microwave oven or Bluetooth device when
performing YP-100 wireless LAN communication.
After checking the above two points, select [Exit] on the [Connection] menu of the Wireless
Connection window to exit Wireless Connection, and then restart Wireless Connection.
You cannot display the Web Setup page
The Web Setup page can be displayed only while there is a wireless LAN connection
between the YP-100 and computer. Use a Simple Connection or Manual Connection to
establish a wireless connection between the YP-100 and computer, and then display the
Web Setup page. For more information, see “Web Setup” (page 64).
If the Web Setup page does not appear even through there is a wireless LAN connection
between the YP-100 and computer, check the following points.
• The Web Setup of the YP-100 may be disabled. Use the procedure under “To enable
and disable Web Setup” (page 66) to check the current setting. If it is “Disable”, change
it to “Enable”.
• The browser you are using may be configured to use a proxy server. This can make it
impossible to display the Web Setup page, and so the proxy server settings should be
canceled. See the help and other user documentation for your browser for information
about proxy server settings.