Filter
Top Products
82
Subnet Mask Configuration of this setting is required when “Off” is selected for “DHCP”.
Enter a subnet mask value, which specifies the range of the IP address of
the subnet to which the YP-100/computer belongs. The subnet mask consists
of four values in the range of 0 to 255, separated by periods (such as
255.255.255.0).
Default
Gateway
Configuration of this setting is required when “Off” is selected for “DHCP”.
When “Access Point” is selected for “Access Mode”, specify the same value
as the wireless LAN access point.
Channel Configuration of this setting is required when “Ad Hoc” is selected for
“Access Mode”. When there is a large number of devices performing wireless
LAN communication using frequencies in the same frequency band (2.4 GHz)
used by the YP-100, you can improve communication performance by
assigning different channels to each wireless LAN network. Normally you
should leave this item set to “Auto” (initial default setting).
Auto*:
Automatically assigns a communication channel for wireless LAN
communication. If “Auto” is selected on the YP-100, also select “Auto” for
the computer as well.
1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11:
Specify a channel that should be used for wireless LAN communication.
The same channel must be set on the YP-100 and the computer that will
be communicating with each other over the wireless LAN connection.
Setting Name Description