Filter
Top Products
Chapter 1 Introducing the Cisco Wide Area Application Engine
Hardware Features
1-10
Cisco Wide Area Application Engine 511 and 611 Hardware Installation Guide
OL-7220-02
Note The MPEG A/V decoder adapter does not have any LEDs.
Input/Output Ports and Connectors
Your WAE appliance supports the following I/O connectors on the back of the
device:
• Ethernet connectors
• Serial connector
• SCSI low-voltage differential (LVD) connector (WAE-611 only)
• Fibre Channel connector (on optional adapter)
• Video and audio connectors (on optional adapter)
Warning
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits
to telephone-network voltage (TNV) circuits. LAN ports contain SELV circuits,
and WAN ports contain TNV circuits. Some LAN and WAN ports both use RJ-45
connectors. Use caution when connecting cables.
Statement 1021
Figure 1-9 shows the location of the WAE back panel ports and receptacles.
Green
Amber
Off
On
Signal has been acquired. (The Fibre Channel
adapter firmware is performing or waiting to
perform Fibre Channel loop initialization.)
Green
Amber
Off
Flashing
Loss of synchronization.
Green
Amber
Flashing
Flashing
Firmware error.
Table 1-4 Fibre Channel Adapter LEDs (continued)
LED State Meaning