Filter
Top Products
3-11
Cisco Wide Area Application Engine 511 and 611 Hardware Installation Guide
OL-7220-02
Chapter 3 Installing the Cisco Wide Area Application Engine
Installing the Cisco Wide Area Application Engine
Note Leave enough slack in the cables to allow for sliding the device in or out
of the rack.
Step 9 To transport the rack to another location with the chassis installed, you must
secure the chassis to the rack.
a. Remove one mounting screw and loosen the other mounting screws as
indicated in Figure 3-10.
Figure 3-10 Securing the Chassis for Transporting in the Rack
b. If necessary, disconnect the cables from the rear of the chassis, then slide the
chassis out of the rack six inches (150 mm).
c. Fully extend the rail, and reinsert the M6 screws in each slide rail. To secure
the rail, tighten all screws. The rails should be fully extended to the rear of
the rack, and the shipping brackets should be installed.
d. Secure the chassis to the rack with the M6 screws.
To remove the chassis from the rack, reverse these instructions. Store these
installation instructions with your product documentation for future use.
134410
Move mounting
screw
Loosen
mounting
screws