Filter
Top Products
4-5
Cisco Wide Area Application Engine 511 and 611 Hardware Installation Guide
OL-7220-02
Chapter 4 Installing Hardware Options
Installing Adapters
Installing an MPEG Decoder Adapter
Note The illustrations in this document might differ slightly from your hardware.
To install an MPEG decoder adapter, follow these steps.
Step 1 Review the safety information in the “Safety Guidelines” section on page 2-4.
Step 2 Power down the device and peripheral devices.
Step 3 Disconnect the power cord and then all external cables from the device.
Step 4 Remove the device cover.
Note You may find it easier to route the cables before you install the adapter.
Step 5 Loosen the captive screw (labeled 4 in Figure 4-3) located on the rear of the
device adjacent to PCI-X slot 1 and remove the expansion slot cover.
Note PCI expansion slot covers must be installed on all vacant slots. This
maintains the electronic emissions characteristics of the device and
ensures proper cooling of device components.